Priming in cold weather

[Anon455]

Originally Posted by wirejock

P60G2 is the wash primer Vans has been spraying on QBs for a very long time.
Ask SW and they will tell you it's not intended as a stand alone primer.
Search and you may find Vans test piece has been outside exposed for close to 15 years with no sign of corrosion.
I sprayed it inside and also sprayed it under Jet Flex. Gorilla Tape test has yet to rip any off. In fact, the one time I needed to remove it, it took scotchbrite and lacquer thinner and a lot of elbow grease.
Personally, I believe it's all about surface prep. Feel free to read my blog.

Thanks Larry - Right now I'm using Azko Noble 10P20-13. In your opinion, should I switch away from this?

Thanks

[wirejock]

Originally Posted by DARV8

Thanks Larry - Right now I'm using Azko Noble 10P20-13. In your opinion, should I switch away from this?

Thanks

No. Go with what you know. Success rate is better.
I have no first hand experience with Akzo but I have sprayed a lot of Kirker EnduroPrime. It's also a 2K epoxy. I'm sure it's just as durable if not more.