What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

14 spinner cutout

jfisher

Active Member
Trying to get the cutout according to the Hartzell template... am I missing the part where I’m supposed to clamp the prop between two blocks of wood the turn it to see my gap clearance on the spinner?
 
I followed the kit instructions for the cutouts - see page 44-07 for instructions on checking prop rotation clearance.
 
Yea, you gotta get the clearance right using the wood studs method. Tape everything so you don't scratch the paint but otherwise fairly easy, iirc it didn't take very long. I think this is one of those steps we spent more time analyzing than doing :D

The part should have lines to get you started, trim from there :)
 
Back
Top