G3X Auto pilot

Can any one confirm the ID Strap wiring for my installation please
For my RV 14 I have two GSA28 servos ( pitch and roll ) and I also have a Ray Allen elevator and aileron trim motors

Have I read the id strap connections correctly for my installation ?

• Pitch servo that incorporates the Ray Allen elevator trim motor …. I connect pins 7 & 8 with a jumper wire

• Roll servo that incorporates the Ray Allen aileron trim motor … i connect pins 5 & 8 and also pins 6 & 7 with jumper wires

This is how i read the instruction manual but i also have a steinair wiring diagram that shows a different pin out ??

I see your confusion. A pitch trim or roll trim is using the GSA28 to run the trim, which you are not. That is what the Ray Allen motors are doing. That just leaves you the roll and pitch servos. no strap on the roll and 5 to 8 on the pitch.

Jay

Thanks Jay

Couldn't get my head around that initially
But that's exactly what Stein have on their drawing

Thanks for your help much appreciated

Mark