Transition from Flox to Canopy

Getting ready to bond the tipover canopy to its fiberglass support structure. Then the canopy edges get filleted to blend with the canopy skirt. I am a little worried that the transition between the flox and acrylic won't be neat and sharp- is there a low profile P- shaped rubber or plastic strip that anyone can recommend to bond into the edge?

(Same idea as tile edge trim on your home renovation)

Thanks

Tall_Order said:

Getting ready to bond the tipover canopy to its fiberglass support structure. Then the canopy edges get filleted to blend with the canopy skirt. I am a little worried that the transition between the flox and acrylic won't be neat and sharp- is there a low profile P- shaped rubber or plastic strip that anyone can recommend to bond into the edge

Click to expand...

Showplanes tip over? All the canopy edges are encapsulated under two plies of fabric. There is no flox edge showing anywhere.

DanH said:

Showplanes tip over? All the canopy edges are encapsulated under two plies of fabric. There is no flox edge showing anywhere.

Click to expand...

Haha using a bit of flox or micro on top to get the transition radius just right