Show us the status of your 9/9A project! - Page 2

339A · #11 07-06-2005, 08:41 AM

Just wanted to show everyone how my interior has turned out from Abby at Flight Line Interiors. It looks Great and was simple to install. Abby does a tremendous job with the kit and she is fantastic to work with.

And this one..

Scott Mills
N339A

Scott DellAngelo · #12 07-12-2005, 12:36 PM

Here was the first fitting of the panel a few weeks ago. Obviously radios and the like (Marker receiver, CDI, Intercom, couple idiot lights, remote ELT) are missing but all the round holes are there. Currently I am waiting on radios and have about as much wired as I can to this point, so I am installing interior now.

Scott
#90598 Finish Kit
N598SD reserved

Don · #13 08-04-2005, 09:24 AM

Yesterday I attached the center section and side skins. The wings are done (no bottom skins) and the empennage is finished. With a little luck I'll be flying this bird next year.

Tom Sampson · #14 08-07-2005, 10:45 PM

I began my 9a 11 months ago. Its a non-quick build, I have been working 22-25 hours a week withoiut any trouble ... and had 6 weeks off between empenage and wings, and 4 weeks off between wings and fuse. The fuse is 99.5% done, and the finish kit will be ready the last week of August. As the "expendable income" gods allow, we should fly by next spring.

Have fitted the wings and tail, which are now tucked away in storage.

Loving the process ... but can't wait for the next segment to begin, and then eventually to fly her.

Tom Sampson
Portland, Oregon
503.590.6575 Direct
RV9a #90535 Fuse at 99%

Visit My Website!
http://websites.expercraft.com/toms/

kentb · #15 09-12-2005, 06:53 PM

Kent Byerley
#90322 N94KJ

Sorry I was not able to get the image to upload.

vlittle · #16 09-12-2005, 07:41 PM

Here's a pic of my RV-9A, completed assembled with wings and tail in my garage, with room to spare.

Since the photo, the engine install is complete, windscreen install is complete, and the prop install is about 50%.

Next thing to do is install the interior from Flightline (which is back ordered). In the meantime, lots of little jobs are being completed.

Engine is a Superior/AeroSport O-320 A1AC2 roller lifter crankcase.

Panel is complete, and is designed to be removable.

Vern Little

N523RV · #17 09-13-2005, 07:53 AM

Last weekend we had a party out our place so I pulled out all the parts and pieces and made them look like an airplane for our guests. Everyone was very impressed. Should have engine in mid-October.

bsacks05 · #18 09-28-2005, 07:33 AM

SmittysRV · #19 09-29-2005, 07:51 AM

I just LUV the Avery Rivet Squeezer!!

N523RV · #20 10-12-2005, 10:19 AM

I installed the panel for what I hope is the last time this past weekend. It's funny to look back on all my past panel designs throughout the life of the project. Particularly since the final design turned out to be very traditional. The panel is missing a TruTrack Autopilot in the lower left instrument hole and I will be installing the new large version of the Dynon on the right side of the panel for my wife to use.