What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Fitting wiring harness

fr0gpil0t

Well Known Member
I'm fitting the Dynon wiring harness and cannot get the connector to the co-pilot's control stick to reach. Does anyone have some images I can look at or check mine to see if there is anything I've miss routed.

I think I have the main harness correct as it leaves the avionics bay. I can't clamp it as the mounting plate for the clamps come in the engine kit. It seems to be about 4 or 5 inches short even after I tried pulling back some of lacing.

This is the wire exiting the avionics shelf

ACtC-3f9t1VupYSyeCVcchbWGlB5K6Vy74VgDycV9Qv1d5CkVNIlLtG72lL77AXJO8WXPnWT_sGuJeVsZZiYq0n38a-VSYogOaGz0LBJfWtDgnch2m7Qq8rtIfGmaV4hRIhwtQ4uSQfxcsBNKpuL_BzI-tO-TA=w709-h945-no-tmp


Then the side of the plane showing the connector short of the cutout it should go into

ACtC-3dtkUnflc4K56CAHZ2YGzXKy3_Ua9s6CLEpSHhNHpWR-4VY0AxSJuZLiHMSFKT0JMPePhfi31OwDm2Wx4mlWw2eSJyaB1K7VOnbdasGxx8AvMkeQtcC2BbX-WcV3hnxWxJ8drah97kQe1ITgNQ6Z8cuqw=w1260-h945-no-tmp




This the wiring under where the throttle quadrant will be

ACtC-3fBdeh-q6fI8MYzkeaxK7yqt1g_W2QH82M41uDi5NqMdB6ZD1vGAYoHMjbODMq3tRmH04ojtzbUEWip2bPTtr7pGvBntzv0BvDpPLBDVpQEvbuqvyI6eK7_ar7tNIK6zwscUF3NRaSpVMix8_Z-dZHi_A=w709-h945-no-tmp
 
Last edited:
Did you get this figured out? It appears you may be trying to reach the wrong hole with the copilot connector because it looks like you have plenty of wire to reach the correct hole, which is down and to the right from the large round hole in your pic.
 
Back
Top