KatieB
Well Known Member
I found a few wear marks on the engine mount as I was taking the engine off the other day. There were PVC (I think) plastic shrouds around the cables in the areas contacting the mount to prevent them from rubbing, but it looks like they didn't do much good. I don't know if there was just a lot of grit that got down in between there or what.
This wear mark is after 450 hours of operation. I think it's just through the powdercoat, but I won't know til I clean it up some. There is a corresponding flat spot on the plastic. There are a few more spots like this as well.
So I post this as a caution to people who might think having the plastic protectors is all you need. And, I'd like to know if there's a better alternative that might not wear so badly. Is there a better material to use for this, or should I just be careful to keep the thing cleaner?
This wear mark is after 450 hours of operation. I think it's just through the powdercoat, but I won't know til I clean it up some. There is a corresponding flat spot on the plastic. There are a few more spots like this as well.
So I post this as a caution to people who might think having the plastic protectors is all you need. And, I'd like to know if there's a better alternative that might not wear so badly. Is there a better material to use for this, or should I just be careful to keep the thing cleaner?