At 75 Hours I took the plane in to get it painted and noticed the heat shield had de-bonded and the metal scorched on the left side of my cowl. I have the newer two heat muff exhaust on my 10 and I wanted to know if anyone else has had this problem and what heat shield might work better?
Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
Burned Cowl
- Thread starter Dave'sRV
- Start date
Bill.Peyton
Well Known Member
I have never seen this on mine. I just used the stick in heat shield. Pictures would help
Dave Stephens
Active Member
Had the same (new type exhaust)
It blistered the cowl
Dave
It blistered the cowl
Dave
Brandi
Well Known Member
I don't know what you're using but the heat shielding from Van's sticks better than anything I've ever bought from Aircraft Spruce. I tore off the junk I had purchased from ACS (what was left of it) and replaced it with the Van's aluminum foil about 200 hours ago. It's been fine.
Van's product: http://vansaircraft.com/cgi-bin/store.cgi?ident=1373961786-236-663&browse=engines&product=cowl_protector
I also sealed our bottom cowl with epoxy before sticking anything to it.
Van's product: http://vansaircraft.com/cgi-bin/store.cgi?ident=1373961786-236-663&browse=engines&product=cowl_protector
I also sealed our bottom cowl with epoxy before sticking anything to it.
