tyconnell
Well Known Member
I don't have a 17/64" drill bit (HomeDepot up the road has one), but I've never needed one, and I'm very curious why the -14 seems to have this different, weird hole size.
I've match drilled the #30, and the hole comes out on the upper VS-410PP Hinge Bracket. Searching through the digital plans, it looks like it's the system hole referenced in the OP-56 Tail Lighting section, and this makes complete sense. What doesn't make sense is that every other model (except the -12) calls for a 1/4" hole to be drilled vs. a 17/64" hole to be drilled.
I'm going to drill it to 1/4" so I can "build on" since upgrading the hole later to 17/64" can be done fairly trivially (I think the F-01412D tie down bracket will be out of the way).
All that aside, does anyone know why this hole would be 1/64" larger than the other models?
I've match drilled the #30, and the hole comes out on the upper VS-410PP Hinge Bracket. Searching through the digital plans, it looks like it's the system hole referenced in the OP-56 Tail Lighting section, and this makes complete sense. What doesn't make sense is that every other model (except the -12) calls for a 1/4" hole to be drilled vs. a 17/64" hole to be drilled.
I'm going to drill it to 1/4" so I can "build on" since upgrading the hole later to 17/64" can be done fairly trivially (I think the F-01412D tie down bracket will be out of the way).
All that aside, does anyone know why this hole would be 1/64" larger than the other models?