David Paule
Well Known Member
I expect that everyone but me knew these things. Here's how:
Fit the white end of the tool over the wire.
Press it into the socket. It goes in quite far. When it's in far enough,
Pull the wire out. It;ll drag the tool with it.
In some instances this technique just won't work. What seems to be the case is that the pin isn't set in properly. Use the red side of the tool to firmly seat it. Then proceed as I described.
(I should say that I knew that the red is the insertion end and the white is the removal end. But that's about all I knew.)
Dave
Fit the white end of the tool over the wire.
Press it into the socket. It goes in quite far. When it's in far enough,
Pull the wire out. It;ll drag the tool with it.
In some instances this technique just won't work. What seems to be the case is that the pin isn't set in properly. Use the red side of the tool to firmly seat it. Then proceed as I described.
(I should say that I knew that the red is the insertion end and the white is the removal end. But that's about all I knew.)
Dave