Darren Kerns
Well Known Member
My 3400s MFD screen was jumping up & down the other day while flying. I removed the screen and the ribbon connector was loose. I hot glued it after talking to others to get it to stay.
I re-installed and now when I turn on the avionic's master, it will go through the various sequences like normal but then go dark or completely black. I never get the "I agree" screen.
After talking to Jonathon at Dynon/AFS, I ordered a new backup battery. Replaced it today but I am still getting the same problem.
The screen is sitting on my kitchen table and I press "1" to test it & I get the same results.
I am sending the screen to AFS tomorrow. Is there anything I am missing? I have given up & I want Rob to fix it.
Thanks
Darren Kerns
RV7 N599DT
I re-installed and now when I turn on the avionic's master, it will go through the various sequences like normal but then go dark or completely black. I never get the "I agree" screen.
After talking to Jonathon at Dynon/AFS, I ordered a new backup battery. Replaced it today but I am still getting the same problem.
The screen is sitting on my kitchen table and I press "1" to test it & I get the same results.
I am sending the screen to AFS tomorrow. Is there anything I am missing? I have given up & I want Rob to fix it.
Thanks
Darren Kerns
RV7 N599DT