I am just getting started on the Wing Kit and I have two questions about the spars.
1.) On the spar assemby W-1206 on page 13-02 step 5, figure 4 why is the extrusion for the Tie Down to be tapped on top and botton rather than just the bottom?
2.) The inboard end of the Rear Spar and Stub Spar have a rounded shape. I have been dressing / cleaning up the rough edges of the parts prior to assembly. What is the purpose of this rounded ended? Is there something that I should be aware of before "cleaning up" these parts?
Many thanks.
Brett
Columbus, IN
1.) On the spar assemby W-1206 on page 13-02 step 5, figure 4 why is the extrusion for the Tie Down to be tapped on top and botton rather than just the bottom?
2.) The inboard end of the Rear Spar and Stub Spar have a rounded shape. I have been dressing / cleaning up the rough edges of the parts prior to assembly. What is the purpose of this rounded ended? Is there something that I should be aware of before "cleaning up" these parts?
Many thanks.
Brett
Columbus, IN