ScottSchmidt
Well Known Member
Today I tried to do the fuel tank calibration and my voltage is stuck at 5 volts. When I measure the resistance of the float it works just fine. Has anyone else seen this?
I have the Skyview with the conversion harness (meaning I received my wiring over a year ago and decided to wait for the Skyview).
When I look at the screen that has the setup information, it is set to "resistivity", yet the calibration page displays 5 volts. I don't quite understand what it is doing there.
I have the Skyview with the conversion harness (meaning I received my wiring over a year ago and decided to wait for the Skyview).
When I look at the screen that has the setup information, it is set to "resistivity", yet the calibration page displays 5 volts. I don't quite understand what it is doing there.