SeattleAviator
Member
I am doing a Pre-buy inspection of an RV-9a and note that some control surfaces (aileron, rudder, elevator) have very little clearance between them and surrounding structure. None of these controls are touching the surrounding structure but wafer thin margins. What is the clearance specification between 1)elevator and horizontal stabilizer at the counterweight end of the elevator, 2) rudder and vertical stabilizer at the top of the rudder, 3) outboard aileron and wing end cap? A jam could spoil my whole day! Also is there an easy way to adjust these clearances.
Thanks for your help.
Thanks for your help.