Mark Albery
Well Known Member
Assembling the components for Page 38-14 step 4, I can't get the C-01442C fixture to cleco into the outboard holes without some slight mis-alignment of the pre-punched holes in the handle and non-flushness of the centre flange.
As it's Sunday, I doubt I'll get a quick response from Van's support, so can someone please check their C-01422C fixture to confirm the distance between hole centres?
Mine measures approx 42 7/8".
Thanks,
Mark
As it's Sunday, I doubt I'll get a quick response from Van's support, so can someone please check their C-01422C fixture to confirm the distance between hole centres?
Mine measures approx 42 7/8".
Thanks,
Mark
Last edited: