I am redoing my RV4 panel, with new Dynon avionics and a Vertical Power VPX. So all the + connections are pretty straight forward, plus wiring harnesses are all there but what about the GROUNDS?
I read that they recommend 2 ground blocks, one for the avionics and one for the rest.
Does that make sense? Where do they typically go? Do I connect them just to the frame as the previous connections all were or do I run a heavier gauge wire to the battery directly?
Thanks for your thoughts and comments!
I read that they recommend 2 ground blocks, one for the avionics and one for the rest.
Does that make sense? Where do they typically go? Do I connect them just to the frame as the previous connections all were or do I run a heavier gauge wire to the battery directly?
Thanks for your thoughts and comments!