Considering routing the CHT, EGT wires for G3X touch engine monitor in the Adel clamps holding the mag fired spark plug wires on valve covers. Thoughts?
Update
Just spoke with Jason Smith at Aerotronics (they built package) & he suggested flipping an additional adel behind plug wire bundle & its adel. Clean, simple just escaped me at the end of a work session. Bundling low voltage signal wires with high voltage not best practice. Didn’t want them flapping in the breeze like I have in the past.
You never know on this forum, you may get input from the person with intimate knowledge on any topic.
Update
Just spoke with Jason Smith at Aerotronics (they built package) & he suggested flipping an additional adel behind plug wire bundle & its adel. Clean, simple just escaped me at the end of a work session. Bundling low voltage signal wires with high voltage not best practice. Didn’t want them flapping in the breeze like I have in the past.
You never know on this forum, you may get input from the person with intimate knowledge on any topic.
Last edited:
