PilotBrent
Well Known Member
Last sentence on this step "Machine countersink the two holes on the inside lower center face of the roll bar that will get flush blind rivets. See Figure 1."
I've countersunk all the outer flange holes on the roll bar, but that this last sentence seems to be referring to two additional holes that I can't seem to locate or understand. Maybe its been too long of a day in the shop.
Anything someone can advise I am missing here?
thanks,
I've countersunk all the outer flange holes on the roll bar, but that this last sentence seems to be referring to two additional holes that I can't seem to locate or understand. Maybe its been too long of a day in the shop.
Anything someone can advise I am missing here?
thanks,