tailcreek_flyer
Active Member
My work area only permits me to fit one wing at a time. Obviously there is some risk in the wing incidence drilling task going this way, not being able to snap a line from tip to tip or measure back from tip to tail ,etc. I am wanting to reduce my final assembly time in the hanger by do as much as possible in the home shop, however I am starting to think that the benefit of doing the wing fitting once I am set up at the hanger outweighs the risks of trying to do it one wing at a time in my shop.
Can anyone share their thoughts or experience on having fit one wing at a time, did it turn out as planned? Did it make you wish you had waited?
Thanks
Cam Andres
RV9A, ready for finally assembly
Aerosport IO360
Can anyone share their thoughts or experience on having fit one wing at a time, did it turn out as planned? Did it make you wish you had waited?
Thanks
Cam Andres
RV9A, ready for finally assembly
Aerosport IO360