woodsideraff
Well Known Member
On page 38-12, step 3, the instructions call for countersinking the four holes on the forward lower flange of the Canopy Rail Angle to fit an AN426AD3 rivet. I understand that the countersinking is to accommodate the SHOP head of the rivet. However, the rivet called for is an 1/8" rivet, not a 3/32" one.
Is the note correct, or is the countersink be done to fit the head of an AN426AD4 rivet?
Is the note correct, or is the countersink be done to fit the head of an AN426AD4 rivet?