It is starting to take shape and look like a fuselage part. A couple of thigs to be careful about is to make sure that you do not confuse the F-1203B with the F-1203P. They look exactly the same, but the holes will not line up when you try to assemble them if you have the wrong part. Use the F-1203P to rivet to the bulkhead assembly. Also, on page 21-02, figure 1, note the use of LP4-3 rivets in 2 of the holes that are machined out in the bulkhead. I didn't and then had to drill out a rivet when I used the long rivet that is used in all of the other holes. For the pictures go to: http://picasaweb.google.com/JimCone1941/RV12ConstructionPhotos101608#