Radomir
Well Known Member
I searched the forum and did not find much *useful* info... You'd think everything's well covered by now
I'm converting from carb to F.I. (*vertical* induction) and need to figure out best place to drill a hole in the firewall for the mixture cable. (this is on my -7A) I am using the VA-182 bracket. Any suggestions? Would drilling a hole right next to the throttle work? Do you need a longer cable then (I have both on hand)
I have to consider a possible interference with the Weldon pump, which will be installed in same place as the old Facet pump (just different angle)..
Would love to see/hear what worked for you...
I'm converting from carb to F.I. (*vertical* induction) and need to figure out best place to drill a hole in the firewall for the mixture cable. (this is on my -7A) I am using the VA-182 bracket. Any suggestions? Would drilling a hole right next to the throttle work? Do you need a longer cable then (I have both on hand)
I have to consider a possible interference with the Weldon pump, which will be installed in same place as the old Facet pump (just different angle)..
Would love to see/hear what worked for you...