Sheet metal brake needed in Sacramento area

Greetings folks. I have a 4' piece of .032 2024-T3 aluminum that needs a couple bends. I'm a bit NE of the Sacramento area. Is there anyone in this area who has a 4' brake who would be willing to let me make a couple bends?

Thanks,

Mike

Bob Kuykendall at HP Aircraft has a 4' brake up at the shop in Arnold, CA. About 2 hr drive for you. PM me and I will give you his phone # if you can't find someone closer.

I have a sheet metal shop in Grass Valley you can use a brake if needed