What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Gasket sealant question

M

Maxrate

Well Known Member
Patron
I’m adding the inverted oil pickup to my vacuum pad and have a thick paper style gasket. Everything I’ve read seems to indicate a dry mating surface. One AP on the field said he smears a very light coat of silicone on. I can’t find anything in the Lycoming service manual. Any advice?
Thanks
 
Release agent

Lycoming often recommends a release agent but they never give a product name.
Builders I asked say dry or a light coat of oil either side just to keep the gasket from sticking.
 
I was lucky to be taught from a local legend engine builder. Have also seen it done, but not mentioned, in a Lycoming engine building video.

Use tite-seal or fuel lube. Put a little on and rub it into both sides of the gasket between you’re thumb and index finger. There should be little excess during assembly.

GM
 
You must log in or register to reply here.
Back
Top