I was talking to Van's today and we got on the topic of the vertical stabilizer. Kevin Miller encouraged me to share with EVERYONE to look at drawing 27A before fitting your VS and specifically the VS-702 TRIM DETAIL in the lower left corner. The drawing calls for the removal of 5/8" of material from VS-702. DON'T DO THAT.
Instead, fit the VS and remove only the amount needed to fit, if any. Removing 5/8" of material is probably too much and will likely require you to fabricate a doubler to add back what you just removed.
Hope that helps.....and arrives in time for everyone.
Instead, fit the VS and remove only the amount needed to fit, if any. Removing 5/8" of material is probably too much and will likely require you to fabricate a doubler to add back what you just removed.
Hope that helps.....and arrives in time for everyone.