Hi,
I'm installing the engine mounts on the lower longerons (29-07 step 8). I installed the CR2113-4-5 as supplied by Van's. I was short one rivet so I ordered a additional one from ACS. When I installed the ACS supplied CherryMax the shop end set differently (more flush). I went and reviewed a couple of experienced RV14 builder sites and I saw both shop ends in their installations.
Are both shop ends acceptable? If not, which one is correct. The rivets in question are the two at the end of the engine mount bracket.
Thanks Jim
[/URL][/IMG]
I'm installing the engine mounts on the lower longerons (29-07 step 8). I installed the CR2113-4-5 as supplied by Van's. I was short one rivet so I ordered a additional one from ACS. When I installed the ACS supplied CherryMax the shop end set differently (more flush). I went and reviewed a couple of experienced RV14 builder sites and I saw both shop ends in their installations.
Are both shop ends acceptable? If not, which one is correct. The rivets in question are the two at the end of the engine mount bracket.
Thanks Jim