mwjohn63
Member
Recently, after having a muffler tang break off, I decided to get the prop/spinner balanced. I checked the blade angle, float weights and synchronized the carbs. Everything looked good, so I flew over to a prop shop in Sellersburg, IN. After spending all day on it, they were unable to get a consistent balance check/correction. The good news is they didn't charge me, the bad news is they were unable to balance the Rotax setup. I'll look for another shop that is more familiar with the Rotax 912ULS after I complete the the SB-00026 (retainer plate install and re-synch the carbs). Any suggestions on doing the dynamic balance (rpm, etc.). Any recommendations for prop shops near the Cincinnati Ohio area.
Thanks,
MJ
Flying RV-12 (170+ hrs and Oshkosh 2019)
N418MJ
Warren County, OH (I68)
[email protected]
http://www.mykitlog.com/mwjohn63
https://www.youtube.com/watch?v=EJdXcjckN6M
2020 dues paid
Thanks,
MJ
Flying RV-12 (170+ hrs and Oshkosh 2019)
N418MJ
Warren County, OH (I68)
[email protected]
http://www.mykitlog.com/mwjohn63
https://www.youtube.com/watch?v=EJdXcjckN6M
2020 dues paid