attackpilot
Active Member
I am going to replace some very bad set 1/8" rivets on my HS. I think that if I try to use normal rivets again, I will just mess them up again. Perhaps if I had a 3X gun. Anyway, someone on the forum recommended using CherryMax structural rivets in their stead. In the Acraft Spruce catalog, it mentions using the G-27 rivet puller to set them. Has anyone set these with a normal rivet puller (Stanley from Avery Tools)? I would hate to have to buy a $100 tool that I am only going to use a couple of time (hopefully).
Thanks in advance.
Joe Hutchison
RV-10 Tailkit
Thanks in advance.
Joe Hutchison
RV-10 Tailkit