mattasmith12
Active Member
A few years back I purchased a low time O-360 for my project. While it sat, my Dad and I thought it would be useful to mount it to an automotive stand. This would allow my Dad to periodically rotate it and move the oil around.
It was removed from the mount to move the project up to Michigan. Yesterday I had the goal of setting the mount up again. Unfortunately, I noted some damage that I'm hoping for some help with. The threaded rod used to mount the engine has scored the sides of the motor mount bolt holes. Each of the 4 holes are scored in some way.
Where do I go from here? What options are there?
If you're planning to mount your engine in a similar fashion, be aware of the potential issues!
It was removed from the mount to move the project up to Michigan. Yesterday I had the goal of setting the mount up again. Unfortunately, I noted some damage that I'm hoping for some help with. The threaded rod used to mount the engine has scored the sides of the motor mount bolt holes. Each of the 4 holes are scored in some way.
Where do I go from here? What options are there?
If you're planning to mount your engine in a similar fashion, be aware of the potential issues!