vinzer
Well Known Member
Hello everyone!
Finally few days ago I was able to pick up my slowbuild fuselage kit. There was some delay due to QA issues and I hopped that all was resolved and all parts will be in. However my kit still has few back ordered parts and specifically
- WD01021-L-1
- WD01021-R-1
- WD1011-L-PC
- WD1011-R-PC
- WD1012-PC
While last three are non-critical at the moment, the first two are main landing gear mounts and I do not have them yet. My question to these of you who already passed that stage of building:
Will I be able to do Section 25 without these and continue with build while finish related to main landing gear mounts part later on with assembled fuselage ? Ideally I prefer to continue with all sections and get gear mounts installed when arrive from VANs. Until what point can I go without absolutely needed these two to be match drilled/installed ? I looked up the assembly instructions but can not figure that out.
Thank you for your input on this!
Vlad
Finally few days ago I was able to pick up my slowbuild fuselage kit. There was some delay due to QA issues and I hopped that all was resolved and all parts will be in. However my kit still has few back ordered parts and specifically
- WD01021-L-1
- WD01021-R-1
- WD1011-L-PC
- WD1011-R-PC
- WD1012-PC
While last three are non-critical at the moment, the first two are main landing gear mounts and I do not have them yet. My question to these of you who already passed that stage of building:
Will I be able to do Section 25 without these and continue with build while finish related to main landing gear mounts part later on with assembled fuselage ? Ideally I prefer to continue with all sections and get gear mounts installed when arrive from VANs. Until what point can I go without absolutely needed these two to be match drilled/installed ? I looked up the assembly instructions but can not figure that out.
Thank you for your input on this!
Vlad