Hello,
The LP24693C296 screw is a SS countersunk screw that is used to capture the main wheel pants into the wheel axles. Those little screws have a slot cut into the threads and some sort of blueish green material in that slot. On my plans they are shown on page 48-7. For a picture of the screw please visit Vans Store and enter the part number
Vans charges almost $ 4.00 per screw. Technically an MS24693C-296 will fit, I am guessing that is the screw they use and then cut and fill that slot.
What is so special about that screw ad the slot. Is this screw re-usable?
Can I use a MS24693-296 with a type of Loctite? I also have the Berringer wheel and brake package with custom axle extenders from a Vans Airforce advertiser. Does this make a difference.
I have asked Vans via their store webs site and have not yet received a reponse.
The LP24693C296 screw is a SS countersunk screw that is used to capture the main wheel pants into the wheel axles. Those little screws have a slot cut into the threads and some sort of blueish green material in that slot. On my plans they are shown on page 48-7. For a picture of the screw please visit Vans Store and enter the part number
Vans charges almost $ 4.00 per screw. Technically an MS24693C-296 will fit, I am guessing that is the screw they use and then cut and fill that slot.
What is so special about that screw ad the slot. Is this screw re-usable?
Can I use a MS24693-296 with a type of Loctite? I also have the Berringer wheel and brake package with custom axle extenders from a Vans Airforce advertiser. Does this make a difference.
I have asked Vans via their store webs site and have not yet received a reponse.