Bushing for manual aileron trim
I'm putting together the manual aileron trim, and there is a .437 snap bushing with a nominal 1/4 diameter that needs to be opened out to 5/16. Vans says use a Dremel; the snap bushing scoffs at the bits available to me. The snap bushing responded to the drill bit as predicted by Vans - destroyed....
Who knows the Dremel attachment to eat that hard plastic? Or is there a better alternative. I suppose I could fashion a Delrin block to take a 5/16 hole and screw it on there....
Ser 140142, RV-14A flying - N1463
Ser 83825, RV-8 building - N8638?
USN Ret, Urologist, AME, Repeat Offender