Karetaker
Well Known Member
Howdy everyone. I want to run wires from my GRT remote mounted EIS, (Engine Information System) to my fuel level floats, but am confused. The EIS Instructions say to use the instructions included with the fuel float. My fuel float is the stock Vans Stewart Warner, but I don't have wiring instructions. Later in the EIS instructions, there is a diagram for generic float wiring and that shows a 470 OHM resistor between the EIS 4.8V excitation wire and the EIS input from the sender. Anyone have a copy of the 385C Stewart-Warner wiring instructions?
Any help appreciated.
Any help appreciated.