Hello, I am riveting the tail cone skins to the bulkeads and came upon a few rivets that I cannot figure out how to set. These are several rivets that join the bulkhead to the skins but fall under a J-stiffener. How do you get to these? Blinf rivet?
In this picture, it is very hard to truly see the rivet is completely under the J-Stiffener. Others were close and I able to use the edge of my back rivet set.
http://elstien.us/RV-10 Build Log and Information/Picture Albums/Tail Cone/DSC05133.JPG
On another note, I clekoed the skins from the inside and back riveted almost 100% of the rivets except the very back of the tail-cone. It came out very nice.
Any help or advice would be appreciated.
In this picture, it is very hard to truly see the rivet is completely under the J-Stiffener. Others were close and I able to use the edge of my back rivet set.
http://elstien.us/RV-10 Build Log and Information/Picture Albums/Tail Cone/DSC05133.JPG
On another note, I clekoed the skins from the inside and back riveted almost 100% of the rivets except the very back of the tail-cone. It came out very nice.
Any help or advice would be appreciated.