VansAirForceForums  
Home > VansAirForceForums

-POSTING RULES
-Advertise in here!
- Today's Posts | Insert Pics

Keep VAF Going
Donate methods

Point your
camera app here
to donate fast.


Go Back   VAF Forums > Model Specific > RV-12/RV-12iS
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 09-21-2021, 06:57 PM
subpar_bucker subpar_bucker is offline
 
Join Date: Oct 2016
Location: Cranberry Twp, PA
Posts: 56
Default Cotter pin insertion for F-00098 in 25iS/U-06

Stupid question: did anyone else have issues getting their cotter pin inserted into the hole in F-00098? Googling doesn't yield anyone else struggling. I put my seats together a few years ago but left this step undone until attempting it today. Eyeballing the hole, it looks very tight. I filed a tiny bit of the short end of the cotter pin hoping that sloping it would ease insertion - but no dice yet.

Any advice appreciated.
Reply With Quote
  #2  
Old 09-21-2021, 08:14 PM
Bob Y Bob Y is offline
 
Join Date: Jul 2017
Location: Piedmont, SC
Posts: 302
Default

Don’t recall this being an issue during my build, but maybe run a reamer through the hole to remove any possible burrs. Might try twisting a hole deburrer on each side of the hole first to chamfer the hole edges a bit.
__________________
Bob Y - builder 12iS E-LSA
N569TT first flight 2/9/2020
#121047
Reply With Quote
  #3  
Old 09-21-2021, 09:33 PM
rcarsey's Avatar
rcarsey rcarsey is offline
 
Join Date: Jul 2012
Location: North Brunswick, NJ
Posts: 273
Default

I remember this being a tight squeeze. I think it was simply a little burr on the hole. You can try some sandpaper or a deburring bit.. or maybe even just an awl. Worse case is you can use a drill bit to open the hole a small amount.
__________________
Rob Carsey, North Brunswick NJ
RV-12iS (N713) / Completed 12/2020
ASEL, Glider, AGI/IGI, LSRM-I, FCC GROL
Reply With Quote
  #4  
Old 09-22-2021, 08:16 AM
subpar_bucker subpar_bucker is offline
 
Join Date: Oct 2016
Location: Cranberry Twp, PA
Posts: 56
Default

Thanks for the suggestions. I was able to clean up the hole (must have been a burr) and insert the pins successfully afterwards.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 10:47 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.