Just received my Garmin roll servo and assembled wiring harness for it from SteinAir. D-sub on each end. No way that's going thru the grommets..not even sure the wiring bundle without the D-subs on the end would go thru. Fairly heavy sheathing around bundle. Is it ok to route through the lightening holes and what would you use to secure the wire bundle thru the lightening holes. Conduit would be too small.
When prewiring for Zip Tips...what type wire do you use?
Can't find anything on techniques for cutting the opening of the bottom skin for the pitot/aoa mast. Gretz mount. Good instructions on mounting the bracket but nothing when it comes to actually cutting into the skin. Get one shot at it!!!
Thanks
When prewiring for Zip Tips...what type wire do you use?
Can't find anything on techniques for cutting the opening of the bottom skin for the pitot/aoa mast. Gretz mount. Good instructions on mounting the bracket but nothing when it comes to actually cutting into the skin. Get one shot at it!!!
Thanks