I accidentally made two left torque tube assemblies for my RV-10 wings. This is the assembly that gets installed at the root of each wing where there is a small but different rotation in the tube ends depending on right wing or left wing. To fix the problem, I drilled new holes in one of the torque tube ends, re-inserted the tube and put in the proper rotation. I think this is all fine but thought it wise to run it by the community. Does anyone see any issues with this fix?
See pics below.
Below the circled holes are new and go straight through.
Compare the completed end with the left. Note the extra holes.
Thanks
See pics below.
Below the circled holes are new and go straight through.
Compare the completed end with the left. Note the extra holes.
Thanks