Rudder rod end bearing starting dim.

As per the instruction the dim should be on page 7 of the drawings but I can seem to find it.
I have the rudder mounted and I am very pleased with it.
Just want to compair the plans to what I have and see why I can't find the info on my plans
Thanks all

The dimensions for the length of the rod end bearings are on there above the
(SEE NOTE 1) markings on the drawing (DWG 7, grid column 5).
Bottom rod end bearing is 1 1/16", middle one is 59/64" and top one 51/64".

When I put on the tail for the final assembly before flying, I had to adjust these just a bit to get them all lined up.