Hi all,
Spent today lacing a run of wires together, got to a section that involved a curve and the tyes would not hold, almost immediately came undone. Went back over some of the tyes on the straight portion and some held, some didn't. I went back to the curve I had been working, did a few more and paid very careful attention to what I was doing (in case I was tired and getting sloppy), and they still came undone. Wondering if I trimmed the ends too close, or I'm tyeing them too tight, or...???
I'm using Method 2 as shown on the Aeroelectric Connection website, with waxed lacing cord. http://www.aeroelectric.com/articles/cable_lace/cable_lace.html
Anyone else ran into this?
TIA
Spent today lacing a run of wires together, got to a section that involved a curve and the tyes would not hold, almost immediately came undone. Went back over some of the tyes on the straight portion and some held, some didn't. I went back to the curve I had been working, did a few more and paid very careful attention to what I was doing (in case I was tired and getting sloppy), and they still came undone. Wondering if I trimmed the ends too close, or I'm tyeing them too tight, or...???
I'm using Method 2 as shown on the Aeroelectric Connection website, with waxed lacing cord. http://www.aeroelectric.com/articles/cable_lace/cable_lace.html
Anyone else ran into this?
TIA