So I'm working on Left Elevator. Gotten down the point where you bend the tabs to close out the left elevator trim tab slot. And I goofed it. It creased and then tore. Pics below. I'm thinking I have two options to repair. The first is stop drill the tear, then smooth out the whole corner. The second is to fab up a riblet and the cut out the tabs completely and rivet in the riblet.
Opinions? Smart remarks?
I haven't asked support at Van's yet since they are shut down due to the fires in the area.
Thanks y'all.
Opinions? Smart remarks?
I haven't asked support at Van's yet since they are shut down due to the fires in the area.
Thanks y'all.