kevinh
Well Known Member
Hi,
I'm rebuilding my trusty CP214 squeezer. I've just ordered the gaskets and leather diaphragm from US tools. But a couple of questions to those who have gone before:
I'm rebuilding my trusty CP214 squeezer. I've just ordered the gaskets and leather diaphragm from US tools. But a couple of questions to those who have gone before:
- I gather than the leather diaphragm goes in totally dry? No lube in the piston section?
- For the rolling bearings, should I look for a grease that seems similar to the old stuff or just use white lithium instead?
- To get the two steel plates out it seems that there is one remaining pin. Should I drive that pin out with a punch and hammer? (I might skip cleaning those parts/bearings if I can't get them out)
