Gasket for airbox to throttle body?

Hello VAF Friends,
Can anyone advise a suitable gasket for the mating surfaces between the airbox and the throttle body for the Lycoming IO-360 engine?
On my recently purchased RV7A, when I disconnected the airbox, I discovered previous owner had used black silicone to create a seal between the two surfaces - doesnt seem like a really good solution to me - but Im also not certain if there is a gasket already pre-cut for this? If not, perhaps a suggestion about what type of material from which to fabricate a good gasket and where I might get it from?

Thanks in advance.

Dan
Oh, FTR, I just made my annual donation to VAF for 2022! I'm in good standing!

I believe this is what you are looking for.

https://airflowperformance.com/index.php/product/fm-150-rsa-5-inlet-gasket/

You can also just cut one out of gasket paper.

Thanks

That looks precisely like what I need. Thank you so much!

Dan

Flyhud said:

I believe this is what you are looking for.

https://airflowperformance.com/index.php/product/fm-150-rsa-5-inlet-gasket/

Click to expand...

That was my next option...

Luckily, I can get the actual gasket, FM150 from Airflow Performance which was sent from another gentleman.

Thank you for the response never-the-less and Merry Christmas!

WingsOnWheels said:

You can also just cut one out of gasket paper.

Click to expand...