I'm installing my stall warning switch in the wing. Want to make sure it works. Here's what I have discovered, so far:
Step 1 - Continuity from center push tab to ground is good
Step 2 - Upper push tab to center tab (ground) are connected (closed) when switch is not activated (down, level flight or at least not stalling, but in fact, these two are connected even when switch is up, ie, stalling. Is this correct?
Step 3 - How do I figure out if the switch works. Been through the wire diagram a couple of times, but can't seem to figure it out. Hence, this post....
Step 1 - Continuity from center push tab to ground is good
Step 2 - Upper push tab to center tab (ground) are connected (closed) when switch is not activated (down, level flight or at least not stalling, but in fact, these two are connected even when switch is up, ie, stalling. Is this correct?
Step 3 - How do I figure out if the switch works. Been through the wire diagram a couple of times, but can't seem to figure it out. Hence, this post....