This is my first experience purging my new Rotax 912is prior to first engine start.
I’ve purged the system twice by hand propping and using compressed air in the oil can. After approximately 60 prop rotations I could only achieve 10psi on my Dynon panel, far short of the 20-40psi Rotax calls out in their video. The Rotax Service Instruction states you need “indicated” pressure, not a specific psi.
Can anyone shed light on this process as I want to make sure I get this right?
Thanks
Rich
I’ve purged the system twice by hand propping and using compressed air in the oil can. After approximately 60 prop rotations I could only achieve 10psi on my Dynon panel, far short of the 20-40psi Rotax calls out in their video. The Rotax Service Instruction states you need “indicated” pressure, not a specific psi.
Can anyone shed light on this process as I want to make sure I get this right?
Thanks
Rich