MS19087
Well Known Member
I'm installing Garmin servos in my RV-14. I am using Vans install kits, materials and instructions, etc. One question - the servos as supplied by Garmin include a bracket that I believe is to be used to prevent an over center situation. This bracket that gets sandwiched between servo shaft and arm. Vans instructions do not provide any information on the use of such bracket. I have not installed them and just followed Van's install instruction exactly. I assume we provide protection for an over center situation by following these instructions and measurements of associated push rods, end stops and rigging.
Any commentary greatly appreciated.
Any commentary greatly appreciated.