MacCool
Well Known Member
In replacing my AFS 4500 with an AFS 5400 on my RV-9A, I now have the ADAHRS in the tailcone instead of under the panel where it was before. I now need to get:
That's a lot of volume to run down the tunnel (bulkhead grommets are full, and not very accessible).
Any ideas on running those things from front to back on a finished RV-9A?
- AOA tubing from mid-fuselage back to the tailcone
- Pitot tubing from mid-fuselage back to the tailcone
- ADAHRS harness from tailcone to the panel
- OAT sensor wiring from ... somewhere...to the ADAHRS
That's a lot of volume to run down the tunnel (bulkhead grommets are full, and not very accessible).
Any ideas on running those things from front to back on a finished RV-9A?