LettersFromFlyoverCountry
Well Known Member
Finished up Section 27 of the RV-12iS and I didn't see any conclusion to the story of the fitting hole in the adaptor just prior to the fuel filter that the instructions have you taping over.
My suspicion is this will be the fitting for the fuel pressure transducer or fuel flow sensor. I don't recall seeing it in the powerplant kit but I'm not at the hangar at the moment.,
The instructions say I MAY want to wait until avionics wiring is done before attaching the tailcone, but I also think I should attach the tailcone so I can install the rear window and then get the canopy done while it's still hot as blazes in Minnesota.
Any reason not to install the transducer now?
Last edited: