AC6-150x2x4x9

Hi Folks!

I am working on my avionics right now, but there is this piece of aluminum U-profile left in my shelf (see topic)
and i could not figure out what i am going to need that for. It kind of drives me nuts.

Any ideas??

Daida

Have you fabricated the forward braces for attaching the wings? If not, it could be the stock material for that??? It is the angle that attaches to the flange on the forward part of the wing/fuel tank...to the fuselage. I will repost tonight and give you the print drawing number to refer too.

Look at DWG 31.....right side of drawing. "F-863 FRONT SPAR ATTACH ANGLE".
These two angles are fabricated from AC6-150X2X4

Thanks a lot!!!
Yes, i still have to make those.
Thanks again for your answer.

Daida

Thread will be closed!