This thread could have gone in several other categories. The info probably only pertains to Rockets or earlier Vans kits which require more fab'ing of parts. While not specifically an aircraft parts vendor, they have a lot of locations throughout the US and world.
They fab’d two custom cables for me (Rudder Cables) for ~ the same amount of money the parts/materials would have cost from ACS; ~55% of the costs of custom fab’d cables from ACS. They also ran the cable through my supplied Polyethylene tube while fab'ing; another time savings. AN/MS Ends are hydraulically swaged with the proper (very expensive) tooling and pull tested. No kludging/"repurposing" of tools to properly swage. Nice % savings were ready the next day.
They fab’d two custom cables for me (Rudder Cables) for ~ the same amount of money the parts/materials would have cost from ACS; ~55% of the costs of custom fab’d cables from ACS. They also ran the cable through my supplied Polyethylene tube while fab'ing; another time savings. AN/MS Ends are hydraulically swaged with the proper (very expensive) tooling and pull tested. No kludging/"repurposing" of tools to properly swage. Nice % savings were ready the next day.
