I’m helping get a new 12iS up and running. It has the G3X dual screen installation and in a box on the PDF screen “ ECS failed” appears but I can’t figure out what this is or how to clear the failure. I downloaded the Operator’s manual but no luck there. Any help would appreciated.
Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
ECS Failed
- Thread starter funflying
- Start date
Longez
Well Known Member
Patrick,
The Electrical Control System (ECS) refers to the functions provided by the GAD 27.
Not sure if a RV-12iS has a GAD 27. I didn't see one on the electrical system diagrams I downloaded for the RV-12iS. If you don't have a GAD 27, be sure that the Electrical Control System is Disabled on the LRU configuration page, or you will see this error.
Steve
Last edited:
rcarsey
Well Known Member
I could be mistaken, but be sure to load the G3X presets from the Van's website https://www.vansaircraft.com/downloads/#GarminG3X
The presets will pre-configure some things, which may take care of this error message you're seeing.
The presets will pre-configure some things, which may take care of this error message you're seeing.
